@phdthesis{oai:fdc.repo.nii.ac.jp:00000125,
 author = {Tashiro, Shu and Kawaguchi, Tomohiro and Hamanaka, Ippei and Takahashi, Yutaka},
 month = {2021-04-07, 2021-04-07, 2021-04-07},
 note = {2020年度, This research was conducted to investigate the bond strength between artificial teeth and a thermoplastic denture base resin for injection molding with different surface preparations for use in flexible resin removable partial dentures. Composite resin denture teeth and acrylic denture resin teeth were bonded to three types of thermoplastic denture base resins for injection molding (polyamide, polyester, and polycarbonate) and a conventional heat-polymerized polymethyl methacrylate (PMMA) resin (control). The ridge lap surfaces of the artificial teeth were classified into four groups based on the type of ridge lap surface treatment applied (n=10): no treatment, ethyl acetate, small T-shaped tunnel, and large T-shaped tunnel. The specimens were tested for bond strength. The results showed that the ethyl acetate treatment was ineffective for enhancing the bond strength (p>0.05) between the artificial teeth and thermoplastic denture base resin for injection molding, whereas the T-shaped tunnel was quite effective in this regard (p<0.05).},
 school = {福岡歯科大学},
 title = {Bond strength of artificial teeth to thermoplastic denture base resin for injection molding.},
 year = {}
}